|
|
FKP Model FK-10 Valve Bag Filler
 A simultaneous fill and gross weighing machine, the FK-10 is a proficient, fluidizing bagger integrating a pressurized product chamber for superior product handling.
More Pictures:
Features:
- Modular design for effortless add-on of multiple units
- All pneumatic controls standard
- Scale assembly and operator gauges mounted at front of bagger
- Full flexure mounted weighing apparatus for consistent support through scale travel
- Low pressure blower not required for fine powders
- Pressure assist product chamber for enhanced control and more rapid filling
- Fluidizing options to suit your product
|
| Operation |
|
The core of the bagger is a fluidizing hopper with an easy-drop plenum bottom and fast opening hopper outlet port. The air required to fluidize the product enters the plenum bottom and is scattered through the perforated fluidizing pad covering the plenum. With properly controlled fluidized air, the product flows freely from the hopper into the bag.
The upper product chamber of the bagger uses a positive sealing butterfly type product infed valve to close the top of the product chamber during the bag filling process. The chamber is then pressurized by either clean, compressed (plant) air, or by a low pressure/high volume positive blower. This added pressurization means faster filling, tighter packed bags, and better weight accuracy. |
| Specifications |
- Height: 7' 9" floor-to-inlet (typical w/30" chamber)
- Width: 19"
- Depth: 82-½"
- Weight: Approximately 950 lbs.
- Bag Weight Range: 20 - 120 lbs.
- Air Requirement: Clean, dry, compressed air
- CFM: 1 cu. Ft./bag/min.
- Pressure: 80 PSI (65 PSI min.)
|
| Scale and Weighing Mechanism |
| The weighing portion of the bagger, which includes the fill spout and bag support, is supported by flexure plates. The standard mechanical scale is a rugged, compact, entirely front mounted unit using only two inverted pivots and two beams. The bag weight is adjusted using counterweights within easy reach of the operator. An electronic scale is optional. |
| Construction |
| The Model FK-10 uses a heavy duty steel structured frame design which is only 19" wide. Multiple units may be stationed side-by-side. Additional units may be added as your production requirements increase. |
| Controls |
| All pneumatic controls are standard. Pneumatic electric controls are also available to interact with special circuitry requirements. Control components are mounted on a panel at the rear of the bagger and are protected by a lift-off cover for ease of access. |
| Options |
- Automatic start, automatic bag discharge, automatic fill tube purge
- Custom fill spouts, air alleviating spouts, replaceable liner spouts
- Drum & Pail filling attachments
- Stainless steel facings, distinctive finishes for corrosive or wash down environments
- Dust hoods to suit requirements
|
| We Also Service |
|
We also service many other pheumatic & auger valve bagging systems including, but not limited to the following manufacturers/models:
- Black Diamond / Bemis
- St. Regis / Stone Container
- MHE / Chantland (1070, 2010, 4010, 4190, 4210)
- HL Stoker (CR, DX, 200)
- Taylor Products
- Choice Bagging 200-900 Series
- Robey Packaging
- Vic System
- Ecc
- Atlantic Packaging
- Eastern Packaging
- Bagging/ Sealing Equipment: ( Titan, Packaging Aids, Nalle, Doboy, ClamCo, Automated Pkg Systems, ID Images)
- Packaging: Geami, KPC Mastercraft, Ranpak, Starflex
|
| Please contact us to discuss your application in detail. |
|
|
